Recent Changes - Search:

Home Projects

Drawing

Camping

Minecraft

Recipes

Ron Stuff

PmWiki

edit SideBar

BrotherWirelessPr


Brother HL-2275DW

Setup wireless

Basic:

Press connect button on back of printer.
Press WAP button on router.

Should see handshake.

http://support.brother.com/g/b/faqend.aspx?c=nz&lang=en&prod=hl2270dw_all&faqid=faq00002037_011

Configure the wireless settings:
Place the Brother machine within range of your WPS or AOSS™ access point/router.

The range may differ depending on your environment. Refer to the instructions provided with your access point/router.
Make sure that the power cord is plugged in.
Turn on the machine and wait until the machine is in the Ready state.

Hold down the WPS or AOSS™ button on your WLAN access point/router for a few seconds.

WPS or AOSS™ button

The length holding down the button may differ depending on the WLAN access point/router. For the information on how to confirm if the WLAN access point/router is ready for use, refer to the instructions provided with your access point/router.
Press the wireless setup button located at the back of the machine for less than 2 seconds as shown in the illustration below.
Press wireless setup button

Use a pointy object such as a ballpoint pen to press the button.
DO NOT press the button for 3 seconds or more, since the machine will change to the PIN Method of the Wi-Fi Protected Setup mode. To clear this mode, wait for 5 minutes or turn the printer power switch off and then turn it on again. After clearing this mode, press the wireless setup button and try from the step 1 again.

The machine will search for an WLAN access point/router that supports Wi-Fi Protected Setup or AOSS™ for 2 minutes. During that time, the Toner LED will blink (turn on for 0.2 seconds and off for 0.1 second).
LED indication - Setting WLAN

The printer is connecting an WLAN access point/router. During that time, the Toner and Drum LEDs will blink (turn on for 0.2 seconds and off for 0.1 second).
LED indication - Connecting WSP/AOSS

Wait until the Ready LED of your machine indicates Connected. The Ready LED will turn on for 5 minutes. This indication means the machine has successfully connected to your WLAN access point/router.
LED indication - Ready

If the Ready LED isn't flashing, the printer fails to connect to your WLAN access point/router.

If the connection failed, check the error code on the printed WLAN report, and click here for more details on the error code.
Wireless setup is now complete.

Please continue to the following steps to install the printer driver for network connection. Even if you have printed with USB connection, you need to install the printer driver for network connection.



This page may have a more recent version on pmwiki.org: PmWiki:BrotherWirelessPr, and a talk page: PmWiki:BrotherWirelessPr-Talk.

Edit - History - Print - Recent Changes - Search
Page last modified on May 15, 2017, at 04:30 PM